HP ProLiant DL140 G3 Server - Manual (Page 18)

System BIOS configuration 18
To change the administrator password:
1. In the Security menu screen, select the Administrator Password Is field, then press Enter.
2. Type the original password in the password box.
3. Type a new password, then press Enter.
4. Retype the new password to verify the first entry, then press Enter again.
5. Press F10 to save the password and close the Setup Utility.
To remove the administrator password:
1. In the Security menu screen, select the Administrator Password Is field, then press Enter.
2. Type the original password then press Enter.
3. Press Enter twice without entering anything in the new and confirm password fields.
4. Press F10 to save the changes you made and close the Setup Utility.
Setup automatically sets the selected password field to Clear.
To reset the administrator password:
If you forget the administrator password, you need to clear the CMOS and reset the BIOS settings to regain
access the Setup Utility. For instructions, refer to the “Clearing CMOS” section on page 21.
Boot menu
Figure 21 Setup Boot menu
Table 15 Boot menu fields
Field Description
[bootable device list] Set the boot search sequence during POST. By default, the server searches for boot devices in
the following order:
1 CD-ROM drive (IDE and USB CD-ROM drives)
2 Removable device
3 Hard drive
4 Embedded NIC1*
5 Embedded NIC2*
* Via PXE (Preboot Execution Environment, remote boot)
Embedded NIC1 PXE Select whether to enable (default) PXE function for LAN port 1.
Embedded NIC2 PXE Select whether to enable (default) PXE function for LAN port 2.