Aastra Telecom 9133i (INSTALLATION GUIDE) - Manual (Page 10)

7 Model 9133i Installation Guide
Installation and Setup
Headset (Optional)
Turn the phone over and locate the headset jack marked
f
. Insert the headset
cord into the jack until it clicks into place. Then route the headset cord
through the lower groove as shown in the previous illustration.
Desk or Wall Installation
Install on the Desk
Route the cables through the opening
in the stand. Attach the stand by
inserting the tabs on the stand (marked
with
o) into the slots on the bottom of
the phone. For a higher viewing angle,
use the slots marked
n.
For a lower viewing angle, use the slots
marked
m. Then push the stand
towards the phone until it snaps into
place. Press the cords into the grooves
provided on the bottom of the stand. This will allow the stand to sit flat on
a desk surface.
Install on the Wall
Connect the Ethernet cable to the wall
network jack (A). Coil the cable into the
space provided on the back of the
phone (B). Then align the phone so the
hooks on the wall plate (C) align with
the wall-mount slots on the back of the
phone, as shown here. Push the phone
onto the pegs, and then slide it down
until it is secure (D).
Note: You may wish to purchase a short
Ethernet cable from a local supplier
for a wall installation. Also, if 802.3af
compliant in-line power is not pro-
vided on your network and you are
installing the 9133i on a wall using a PoE in-line power supply, you may also
wish to use an equivalent flat Ethernet cable rather than the one provided.