HP Graveur de CD interne HP CD-Writer Plus 7570i - Manual (Page 36)

Installing CD-Writer Plus and Software English-4
E
n
g
lis
h
Or, if your computer has an IDE hard drive or CD-ROM drive, follow the
data cable from the back of a drive to find the IDE controller. IDE
connectors may be labeled as PRI and SEC, IDE-0 and IDE-1, IDE-1 and
IDE-2, HD and CD-ROM, or PCI-IDE and ISA-IDE.
17. Refer to the Install Recommendation Printout to see if you will have one
or two devices connected to the data cable. See page 5 for examples of
one- and two-device installations.
18. Make the necessary data cable connections for your system. Make sure
the cable’s colored edge is aligned with both PIN-1 on the drive and PIN-
1 on the IDE controller. If the cable is attached incorrectly, your
computer may not boot up.
PIN-1
Look for a label identifying PIN-1 next
to the IDE connector. The data cable’s
colored edge is aligned with PIN-1 of
the IDE connector. This illustration
shows a specific computer. Yours may
look different. PIN-1 could be on
either side of the IDE connector.
PIN-1
The cable’s colored edge i
aligned with PIN-1 on the
CD-Writer Plus drive.
Colored stripe on the data cable
Colored stripe on the
data cable