ATTO Technology 1550D - Manual (Page 41)

xii
SpeedWrite
Improves the performance of SCSI WRITE commands to
target devices attached to the iPBridge. Specify all to set
the Speed Write state for each currently mapped device
on the iPBridge, or to get a list of the Speed Write states
of all currently mapped devices on the iPBridge.
Default: disabled
set SpeedWrite SCSI [ sb st sl | all] [enabled | disabled]
get SpeedWrite SCSI [ sb st sl | all]
SpeedWriteDefault
Specifies the default SpeedWrite state applied to new
device mappings created manually or using an AutoMap
operation.
Default: disabled
set SpeedWriteDefault [enabled | disabled]
get SpeedWriteDefault
TailEventLog
Displays new events to the terminal. Type quit then
press ENTER to exit tail mode.
TailEventLog
Time
Controls or displays the current time as clocked by the
iPBridge in 24 hour format.
set Time [HH: MM: SS]
get Time
TimeZone
Controls or displays the time zone or an offset from GMT.
Default: EST
set TimeZone [[EST | CST | MST | PST] | [[+| -]
[HH]:[MM]]]
SaveConfiguration command required
get TimeZone
Username
Specifies the user name for all sessions. It is case
insensitive, 1 to 32 characters, and cannot contain
spaces.
Default: root
set Username [username]
SaveConfiguration command required
get Username
VerboseMode
Controls the level of detail in CLI Help output and
command response output for the current CLI session.
Default: enabled
set VerboseMode [enabled | disabled]
get VerboseMode
VirtualDriveResponse
Provides proxy responses to SCSI INQUIRY and TEST
UNIT READY commands if a SCSI device selection times
out or has a busy event. Host systems can assign devices
consistently regardless of the device’s state during the
execution of the commands.
Default: disabled
set VirtualDriveResponse [enabled | disabled]
get VirtualDriveResponse
VLAN
Sets Virtual LAN ID values for each Ethernet data port.
Up to 8 IDs can be stored per port. Incoming packets are
filtered if their tags are not on the list of VLAN IDs for that
data port. Outgoing packets are tagged to match their
connection. Each VLAN ID is assigned a VLAN name of
up to 64 characters. If no VLAN IDs exist for a data port,
VLAN is disabled for that data port.
set VLAN [dp1] [[VLAN ID] [VLAN Name] | [all]
[delete]]
get VLAN [dp1]
Exhibit A-3 Default history Control table (buckets and interval in hexadecimal) for the RMON CLI
command.
Idx DataSrc BktReq BktGrant Interval Owner Status
====================================================================
001 43.6.1.2.1.2.2.1.1.1 00000032 00000032 0000001e monitor 00000004
002 43.6.1.2.1.2.2.1.1.1 00000032 00000032 00000708 monitor 00000004
003 43.6.1.2.1.2.2.1.1.2 00000032 00000032 0000001e monitor 00000004
004 43.6.1.2.1.2.2.1.1.2 00000032 00000032 00000708 monitor 00000004
005 43.6.1.2.1.2.2.1.1.3 00000032 00000032 0000001e monitor 00000004
006 43.6.1.2.1.2.2.1.1.3 00000032 00000032 00000708 monitor 00000004