ATTO Technology 1550D - Manual (Page 39)

x
RMON
Displays Ethernet data and allows data collection at
specified intervals. Get displays hex.
Valid range for bucketsRequest= 1-180
Valid range for ethernetStat index = 1-3
Valid range for historyControl = 1-6
Valid range for ethernetHistory index = 1-6
Valid range for sampleIdx = 1-2147483647
Valid range for interval = 1-3600
Default: See Exhibit A-3 on page xii of the Appendix
set rmon [idx] [bucketsRequest] [interval] [valid | invalid]
get rmon [ethernetStat | historyControl]
get rmon [ethernetHistory]
Route
Assigns an iSCSI protocol address to a target destination
device. If you try to map a new SCSI BTL to the same
iSCSI LUN, the new BTL overwrites the previous map.
Using the Delete identifier instead of SCSI removes the
map from its map table. In verbose mode, overwriting a
map requires secondary confirmation.
Route [iSCSI] [default | Target Name] [lun] [SCSI
sl> | Bridge | Delete]
RouteDisplay
Displays a combined list of iSCSI to SCSI bus, target,
LUN mappings. The optional target name limits the list to
maps which have that target name. The optional LUN
parameter limits the list further to the map which satisfies
a search for the given LUN.
RouteDisplay iSCSI | Target Name >
SaveConfiguration
Issued with the restart option, cycles iPBridge power
after saving configuration changes. The norestart
option saves changes without restarting.
Note
Certain modifications require a system restart.
SaveConfiguration
SCSIDomainValidation
Runs Domain Validation tests on the SCSI system which
may detect problems with SCSI cables, termination or
damaged transceivers. Tape drives attached to the
iPBridge should be loaded with media. The media is not
overwritten. Disable
VirtualDriveResponse before
running this test and reboot the iPBridge after running the
test.
SCSIDomainValidation
SCSIInitID
Specifies the persistent SCSI initiator ID used by the
iPBridge on this SCSI bus. All maps coinciding with the
user-specified ID are destroyed after this command is
issued.
Default: 0x07
set SCSIInitID [sb] [0-15]
get SCSIInitID [sb]
SCSIPortBusSpeed
Controls the transfer rate at which the iPBridge attempts
to negotiate with its SCSI devices.
Default: ultra320
set SCSIPortBusSpeed [sb] [fast | ultra | ultra2 | ultra160
| ultra320]
get SCSIPortBusSpeed [sb]
SCSIPortList
Lists the status of the SCSI port.
SCSIPortList
SCSIPortReset
Resets the SCSI bus.
SCSIPortReset [sb]
SCSIPortResetOnStartup
Controls whether the SCSI bus is reset each time the
iPBridge is powered up.
Default: enabled
set SCSIPortResetOnStartup [sb] [enabled | disabled]
get SCSIPortResetOnStartup [sb]
SCSIPortSyncTransfer
Controls the iPBridge attempts to negotiate synchronous
SCSI transfers with devices on the specified bus.
Default: enabled
set SCSIPortSyncTransfer [sb] [enabled | disabled]
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures the SCSI internal termination of the specified
SCSI port. Enabling termination allows the iPBridge to act
as a terminator at the end of a SCSI chain.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
get SCSIPortTermination [sb]