beautypg.com

Reboot the server – HP StoreEver Ultrium Tape Drives User Manual

Page 30

background image

Figure 27 Connecting the SAS cable to the server

1. SAS connector on server

3.

Connect the SAS and power cords to the tape drive and plug the other end of the power cord
into the power outlet.

Figure 28 Connecting the cables to the tape drive

3. Power on/off switch

1. SAS connector

2. Power connector

Reboot the server

Switch on the tape drive and power up the server. The power on/off switch is on the front panel.

Watch the boot screen carefully after installation. If there are any error or unexpected messages
go back and check the SAS cabling carefully.

If this does not resolve the problem, refer to

Troubleshooting (page 48)

for further guidelines.

30

Installing an external LTO Ultrium tape drive

See also other documents in the category HP Storage: