Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 91)

Solaris
Manual No. 775079 7-7
7
S
O
L
A
R
I
S
13. Press to continue.
You will see the Bus Enumerating screen with the following message:
“Determining buses...” is displayed.
The Scanning Devices screen is then displayed. System devices are
scanned. When scanning is complete, the Identified Devices screen is
displayed.
14. Press to continue.
You will see the following message:
Message: “Loading driver com.bef...” is displayed.
The boot Solaris screen is then displayed.
15. On the Boot Solaris screen, select the device controller attached to the
device that contains your install medium, in this case the main system
disk.
The following script is displayed when new hardware is found.
/etc/bootrc
16. At the prompt, type: (reboot)
b -r
This reboot process concludes the installation of new or updated
drivers. When your computer has rebooted, you can use your new
hardware.