Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 74)

Overview
6-2 Manual No. 775079
6
U
N
I
X
W
A
R
E
Special Notes
• In order for UnixWare 2.1.2 and below to detect a Mylex multifunction
controller such as a DAC960PG, DAC960PJ, DAC960PR,
DAC960PT, etc., UnixWare 2.1.2 and below must have a
“multifunction PCI Driver” loaded.
• In order to install a Mylex multifunction controller, a driver diskette
must be created from the CD-ROM. See “Creating a Driver Diskette
for UnixWare” on page 6-3.
• If using a Mylex multifunction controller as a primary controller
1
,
please refer to “Installing the Mylex Disk Array Controller as the
Primary UnixWare Controller with UnixWare 7.x/2.1.3” on page 6-3.
• If using a Mylex multifunction controller as a secondary controller
2
,
please refer to “Installing the Mylex Disk Array Controller as the
Secondary UnixWare Controller with UnixWare 7.x/2.1.3” on page 6-
5.
• If using a Mylex multifunction controller as a primary controller,
please refer to “Installing the Mylex Disk Array Controller as the
Primary UnixWare Controller with UnixWare 2.1.2” on page 6-6.
• If using a Mylex multifunction controller as a secondary controller,
please refer to “Installing the Mylex Disk Array Controller as the
Secondary UnixWare Controller with UnixWare 2.1.2” on page 6-8.
1. “Primary” indicates that a controller’s storage device will be the
boot device for UnixWare installation.
2. “Secondary” indicates that the controller is not the bootable
device for the UnixWare operating system.