Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 90)

Installing Solaris Using the Mylex MDAC Supplemental Driver Diskette
7-6 PCI Disk Array Controller Drivers Manual
You will see another message and prompt:
Installing package
Do you want to continue with the installation of
?
If the driver is the one you want to install, at the prompt, type y for yes
or press . If the driver is not the one you want, type n for no.
☛
Note
Be sure to wait for the following “successful”
message to appear. It is somewhat delayed. If the
process is interrupted before it appears, the
installation will not be completed.
If you select y for yes, the install.sh script installs the driver. You will
see the following message:
Installation of was successful.
8. When you’re done and the install.sh script exits, unmount the diskette
by typing the following command lines:
# cd /
# umount /mnt
9. Remove the Mylex Supplemental Driver diskette from the disk drive.
10. Reboot your computer, type in the following command lines.
# touch /reconfigure
# reboot
11. Turn off your computer, add the new hardware, and turn on your
computer again.
12. When the autoboot sequence prompt is displayed, quickly press
Escape.
The autoboot sequence is interrupted. The Solaris Device
Configuration Assistant screen is displayed.