Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 22)

Installing the Mylex Disk Array Controller as the Primary NetWare 5.0 Controller
2-8 PCI Disk Array Controller Drivers Manual
☛
Note
In order to enable the CD-ROM boot, the controller’s
BIOS must be enabled.
4. If the controller’s BIOS is disabled, press > to enable the BIOS.
5. Use the arrow key to select “CD-ROM boot disabled” and press
to enable the CD-ROM boot.
6. Press , then press any key. This will restart the system with the
new settings.
The system will now boot from the NetWare 5.0 CD-ROM.
7. Return to the section “Installing NetWare 5.0 Drivers” and follow steps
4 through 7 to complete your driver installation.
Installing Peripherals Under NetWare 5.0
Non-disk peripheral devices, such as tape or CD-ROM drives, can be
installed on any channel of the controller. Each disk or non-disk device will
require a unique SCSI ID, different from any other device connected to the
channel.
Each device requires a driver module connecting it to the DAC adapter.
These modules are best loaded in the STARTUP.NCF file before the
MDAC.HAM driver.
The common devices and required modules are:
SCSI disk drives SCSIHD.CDM
(including Mylex
RAID system drives)
SCSI CD-ROM SCSICD.CDM
SCSI tape drive NWTAPE.CDM
Magneto optical drive SCSIMO.CDM
DLT tape drive DLTTAPE.CDM
IDE CD-ROM IDECD.CDM
IDE disk drive IDEHD.CDM
ASPI compliant NWASPI.CDM
applications such
as GAM