Electrolux EXM24HV1WE - Manual (Page 11)

11
Connected
Vinyl tape
Tailing 2
Tailing 1
bulge
Flooded
distortion
Do not put the
hose end into
water
Do not block water flow
with a rise.
step 4: installation of indoor Unit
The piping can be output from right, rear right,
left or rear left.
3 Wrap the insulating pipe with wide vinyl tape
to prevent the shift of insulating pipe. Slant
the drain hose downward slightly for smooth
drainage of condensing water.
Insulating pipe
Outlet pipe of
indoor unit
• Cut off the tailings 1 when routing the
wiring only.
• Cut off the tailings 1 and tailings 2 when
routing both the wiring and piping.
Indoor Unit outline
Connection piping
1 When routing the piping and wiring from the left
or right side of indoor unit, cut off the tailings
from the chassis when necessary (see figure
below).
2 The drain hose can be connected at two
different positions. Use the most convenient
postion and, if necessary, exchange the
position of drain cap and drain hose.
1 The insulating tube should be connected reliably
with the sleeve outside the outlet pipe.
2 The drain hose should be slanted downward
slightly, without distortion, bulge or fluctuation.
3 Do not put the outlet in the water.
• The drain hose is connected at the
rear left side of the indoor unit when
you receive the product.
Drain hose
(connected at
the rear left side)
Refrigerant
Piping
Drain hole
Drain cap
caution