Canon VB-C300 - Manual (Page 75)

3-31
NC
Vie
wer and
Vie
wer Switc
her
Setup Properties
Configuring Connection Settings
You can configure audio settings as well as automatic reconnection when the camera and NC
Viewer are disconnected due to a network trouble or other reasons.
To make settings ...
1. Choose “Setup Properties” from the
Administrator menu bar.
2. Set audio connection and automatic
reconnection under “Connection
Settings”.
1 Send and receive audio
Check this option to transmit and receive
audio. You need other settings to transmit
or receive audio (
→ P.1-14).
2 Reconnect automatically
Check this option to automatically
reconnects to the camera.
By checking the Reconnect automatically
option, you can automatically reconnect to
the camera when you are disconnected
from it due to a network trouble or camera
reboot. If reconnection fails, it will be retried
again in 30 seconds.
Click “OK” when finished.
3. When the message “Try new property setting. OK ?” appears, click “OK”.
1
2
Operating and Setting Camera as Administrator
Note
The audio connection is not reestablished even if the Reconnect automatically option
is checked. You need to reestablish the audio connection from the NC Viewer.