Canon VB-C300 - Manual (Page 58)

3-14
Setting Camera Control
You can click on the button from the dialog to change the camera’s pan, tilt, and zoom settings.
You can also set focus.
To Make Settings...
1. Click “Start Control” to obtain camera
control.
2. Click “Camera Control” on the toolbar.
3. The Camera Control dialog appears.
1 Pan/Tilt button
Pan and Tilt movements occur in the direction
of the arrows on the buttons. Operation
occurs when the button is held down and
stops when it is released. When the “center”
button is clicked, the camera faces front.
2 Focus
Switch the focus to “Auto”, “Auto (for
domes)”, “Fixed at infinity”, or “Manual”.
Auto: Focus is adjusted automatically.
Auto (for domes): When the optional dome housing is used, select this option to
automatically adjust the focus without focusing on the dome surface.
Fixed at Infinity: Focus is fixed at a point of infinity.
Manual: Hold Down the Far or Near buttons to adjust the focus. Clicking “One-shot AF”
adjusts the focus automatically and fixes the focus with Manual Focus mode.
1
2
3 4
Overview of NC Viewer Operation
Note
● The NC Viewer’s focus setting takes precedence over the focus mode set on the
setting page.
● The NC Viewer’s focus setting is not reflected on the settings page therefore, it
can only continued with the NC Viewer.
● Note that focus will be fixed if you choose the manual focus mode.
● The NC Viewer’s focus setting is reflected on other Users’ focus setting.
● If you specify the shutter speed within the range from NTSC: 1/1 to 1/4, PAL: 1/1 to
1/3 with Manual Exposure (
→ P.3-28), Auto, Auto (for domes), and One-Shot AF
for camera control will be invalidated. Change the focus mode to Manual and adjust
the focus.
● For the focusing range when the camera is set to Night Mode (→ P.1-10, 3-29)
refer to the Tip on P.1-10.