Axis Communications Axis Network Scan Server 700 - Manual (Page 73)

Appendix A: Troubleshooting AXIS 700 User’s Manual 72
Error Conditions This table lists a summary of error conditions:
Status Indicator On If the Status indicator remains on after startup, this may indicate an
error. Most likely, there is a problem with the scanning device
communication. The message display will indicate possible error
status.
Network Indicator Off The Network indicator flashes when there is network traffic. If it
remains off and you know there is network activity, check the network
connection.
Event
Status
LED
Busy
LED
Network
LED
Remarks
Power up On Off Off
Check SCSI cable to scanning
device
Off Off Off Check RJ45 cable to network
Idle Off Off Off
Check RJ45 cable to network. If
known network traffic, the
Network LED should flash.
Error in EEPROM Blink Off Off Consult Network Administrator
Error in FLASH
PROM
Flash Off Flash Consult Network Administrator
Error in SRAM Flash Flash Off Consult Network Administrator
Error in
DRAM/DIMM
Flash Off Off Consult Network Administrator
DRAM/DIMM
configuration
error
Flash Flash Off Consult Network Administrator
SW-HW
combination error
Flash Flash Flash Consult Network Administrator
Illegal serial no. Flash Flash Flash Consult Network Administrator
Flash load failed Flash Off Off Consult Network Administrator