Brother MFC-820CW - Manual (Page 32)

Installing the Driver & Software
30
STEP 2
Ma
c
in
tos
h
®
Wi
re
d
Netw
o
rk
Macintosh
®
10
Carefully route the network cable through the
trench and out the back of the machine as
shown below.
Then, connect the cable to your network.
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
In case of using both USB and LAN cables, route
both cables into the trench with one on top of the
other.
11
Lift the scanner cover to release the lock.
Gently push the scanner cover support down
and close the scanner cover.
12
Turn on the machine by plugging in the power
cord.
Improper Setup
If you have setup wireless networking on your
machine before and you setup the wired
network, you should check that the machine’s
Network I/F is Wired LAN. The wireless
network interface will be inactive with this
setting.
On your machine, press Menu.
Press a or b to choose LAN and press OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose Wired LAN and press
OK.
Press 1 for Yes to accept the change. The
machine will restart automatically.
13
Choose Network and then click OK.
14
If you want to use the machine’s Scan key to
scan over the network you must check the
Register your computer with the “Scan To”
functions at the machine box. You must also
enter a name for your Macintosh
®
in Display
Name. The name you enter will appear on the
machine’s LCD when you press the Scan key
and choose a scan option. You can enter any
name up to 15 characters long.
(For more information on network scanning,
see Chapter 11 of the Software User’s Guide
on the CD-ROM.)
15
Click Browse.
16
Choose your model name, and then click OK.
17
Click Go, then Applications.