Brother Innov-is 6000D - Manual (Page 15)

14
4. Press to initiate the calibration
process. For safety please make sure area
around needle is clear prior to pressing
.
→ Setting the needle drop point begins.
e
The operation is finished when “OK” appears.
If “NG” appears, remove the sticker, and then
follow the on-screen instructions to repeat
steps 3 and 4 of Step
d
. If multiple attempts
to set the position are not successful, contact
your nearest Brother dealer.
f
Remove the sticker, and then turn off the
machine.
Practice (Connecting Three Patterns)
In order to practice aligning pattern edges by using the
camera, we will connect three patterns as shown
below. These 3 patterns for practicing are available on
the included CD.
a Pattern1X.pes
b Pattern2X.pes
c Pattern3X.pes
a
Select the first pattern (1) for practicing, and
then press
.
b
Thread the machine with the upper thread
and the bobbin thread.
Note
• When using the camera to connect patterns, use the
needle that was installed when the camera needle
position was set.
Note
• Use USB media or a computer to access the pattern
files.
manual sample