Brother PT-2700 - Manual (Page 81)

1
2
3
4
5
6
7
8
9
75
z
TRO
U
BLESHOOTING
Error Messages
When an error message appears on the display, follow the directions provided below.
Error Messages
Press any key to clear the error message.
Message Cause/Remedy
The installed batteries are getting weak.
• The batteries are installed with the negative and positive
end in the wrong position, or other type batteries are mixed
with alkaline batteries. Install eight AA-size alkaline
batteries (LR6) in the correct position.
• The installed batteries are about to run out. Replace with
new batteries or connect the AC adapter before continuing.
An incompatible AC adapter is connected. Use only the AC
adapter designed exclusively for your P-touch labeler.
The tape cutter is closed when you try to print or feed tape.
Turn the P-touch labeler off and then on again before
continuing.
When tape is tangled in the cutter, remove the tape.
There is no text, symbols or bar code data entered when you
try to print or preview a label. Enter data before continuing.
There is no tape cassette installed when you try to print or
preview a label, or feed tape. Install a tape cassette before
continuing.
The tape cassette is changed while printing, etc. Make sure
the correct tape cassette is inserted before printing.
There are already seven lines of text when you press the
key. Limit the number of lines to seven.
There are more than five lines of text when you press the
or key while using 3/4" (18mm) tape. Limit the
number of lines to five, or replace with tape cassette of larger
tape width.