Brother PT-2700 - Manual (Page 80)

TROUBLESHOOTING
74
What to do when...
The label is not cut
automatically. Is Cut Option set to Chain or
No Cut? When these options are set,
the tape is not fed after
printing the label. Check the
Cut Option setting, or hold
down the
key and press
the key to feed and
cut the tape.
Is Manual Cutting set to ON? When using Fabric Iron-On
Tapes or Extra Strength
Adhesive Tapes, please use
scissors to cut the tape after
printing.
When using other tapes,
refer to “Manual Cutting” on
page 64 and set the Manual
Cutting to OFF to cut the
tape automatically.
Label files saved
previously are now
empty. Have the batteries and AC
adapter been disconnected? All files stored in the internal
memory is lost if the
batteries and AC adapter are
disconnected for longer than
one minute.
Is there enough power
remaining in the batteries? All data stored in the internal
memory is lost if the
batteries become empty.
Have you used the Reset
function? The reset function clears all
data stored in the internal
memory, including label
files.
Problem Cause Solution