Brother HL-3045CN - Manual (Page 15)

15
Macintosh Wired Network
Windows
®
Macintosh
Wired Network
For Wired Network Interface Cable Users
8 Connect the printer to
your Macintosh and
install the driver
a
Connect the network interface cable to the LAN
connector marked with a
symbol and then
connect it to a free port on your hub.
b
Make sure the printer power switch is on.
c
Turn on your Macintosh. Put the supplied CD-
ROM into your CD-ROM drive.
d
Double-click the Start Here OSX icon. Follow
the on-screen instructions.
e
Follow the on-screen instructions until this
screen appears. Choose your machine from
the list, and then click OK.
f
When this screen appears, click Next.
Note
It may take a few minutes for installation to
complete.
Note
• If there is more than one of the same model
connected on your network, the MAC Address
(Ethernet Address) will be displayed after the
model name.
• You can find your machine’s MAC Address
(Ethernet Address) and IP Address by printing
out the Printer Settings Page. See Print the
Printer Settings Page on page 16.
Note
When the Brother Support screen appears,
make your selection and follow the on-screen
instructions.
Finish
The installation is now
complete.
Note
If you use a specified IP Address for the machine,
you must set the Boot Method to Static by using
the BRAdmin Light. For more information, See
Configuring your machine for a network in the
Network User’s Guide.