Brother MFC 8220 - Manual (Page 16)

UNIX PRINTING 1 - 3
NC9100h_FM6.0
The actual format of the entry may vary depending on your system,
check your system documentation and also note the format of other
entries in the
/etc/hosts file.
In any case, the node name in the /etc/hosts file must match the
node name in the /etc/printcap file.
Some systems such as HP-UX and AIX allow you to enter the IP
address as the host name when setting up the print queue. If this is
the case, you do not need to configure the hosts file.
2 Choose which Print/Fax server service you want to use. There
are several types of services available on Brother Print/Fax
servers. Binary services pass data through unmodified and are
therefore required for PCL or PostScript rasterized graphics
printouts. Text services add a carriage return at the end of each
line for proper formatting of UNIX text files (which end in linefeed
and do not have carriage returns). The text service can also be
used for non-rasterized graphics, such as ASCII PostScript
graphics or many types of PCL graphics.
Choose one of the available services (a service name will be
used in step 3):
BINARY_P1 Binary data
TEXT_P1
Text data (CR added)
You may set up multiple print queues on your UNIX host
computer for the same Print/Fax server, each one with a
different service name (for example, one queue for binary
graphics jobs and one for text jobs).
The node name in this file does not necessarily need to be
the same as the one that is actually configured into the
Brother Print/Fax server (the name that appears on the
printer configuration page), however, it is good practice to
make the names the same. Some operating systems, such
as HP-UX, do not accept the “_” character in the default
name, for these systems you must use a different name).