Brother MFC-665CW - Manual (Page 74)

Chapter 7
58
• If You Do Not Subscribe to Distinctive
Ring Service:
You must plug your TAD into the EXT.
jack of your machine. If your TAD is
plugged into a wall jack, both your
machine and the TAD will try to control the
phone line. (See the illustration below.)
1 TAD
When the TAD answers a call, the LCD
shows Telephone (MFC-440CN) or
Ext. Tel in Use
(MFC-665CW and
MFC-845CW).
Connections
7
The external TAD must be plugged into the
jack labeled EXT. Your machine cannot work
properly if you plug the TAD into a wall jack
(unless you are using Distinctive Ring).
a
Plug the telephone line cord from the
telephone wall jack into the jack labeled
LINE.
b
Plug the telephone line cord from the
external TAD into the jack labeled EXT.
(Make sure this cord is connected to the
TAD at the TAD's telephone line jack,
and not its handset jack.)
c
Set your external TAD to four rings or
less. (The machine's Ring Delay setting
does not apply.)
d
Record the outgoing message on your
external TAD.
e
Set the TAD to answer calls.
f
Do one of the following:
„ (For MFC-440CN)
Set the Receive Mode to External
TAD
.
„ (For MFC-665CW and MFC-845CW)
Set the Receive Mode to Manual
with Easy Receive turned on.
(See Choosing the Receive Mode on
page 46.)
1
1