Acer Altos R920 Series - Manual (Page 100)

3 System upgrade 82
Removing and installing a non-hot-plug PCI card
PCI cards installed in slots 1 and 2 are hot-pluggable. If you are adding
or removing a card from one of these slots, you can do so without
powering down the server. For information, refer to page 59.
To remove a non-hot-plug PCI card:
Caution! Damage to the system occurs if power is not removed
from the system prior to removal or installation of non-hot-plug
boards.
1 Perform the pre-installation instructions described on page 39.
2 Disconnect any cables attached to the PCI card.
3 Perform steps 5 through 10 described in the “To remove a hot-plug
PCI card with OS hot-plug interface” section on page 59.
To install a non-hot-plug PCI card:
1 Perform the pre-installation instructions described on page 39.
2 Perform steps 2 to 8 described in the “To install a new hot-plug PCI
card” section on page 62.