Ouellet OWS - Manual (Page 2)

WARNINGS AND CAUTIONS
Risks of electrical shocks and fire
For safe installation and efficient performance of this system, read the instruction manual
thoroughly and keep it handy.
• Where applicable, installation must meet requirements of the following codes :
- Canadian Electrical Code (CSA C22.1 Part 1);
- National Electrical Code (NFPA 70);
- Any other applicable local and/or national code.
• Where required by law, this product must be installed by a qualified individual.
• To prevent any possibility of electrical shocks, the power supply must be turned off
before handling the heating cables.
• This product must be installed with a ground fault circuit interrupter (GFCI), in
compliance with the Canadian Electrical Code (CSA C22.1 Section 10) and the National
Electrical Code.
• Reinforcing bars, wire mesh and other conducting material used for support or on
which heating cables are installed, must be grounded, in compliance with the Canadian
Electrical Code (CSA C22.1 Section 10) and the National Electrical Code.
• Heating cables must be used for outdoor applications only.
• Heating cables must be installed and fully embedded in concrete, asphalt, stone dust
or other similar material, before the system is connected.
SAVE THESE INSTRUCTIONS