Ouellet OVE User Manual

Installation instructions “ove series

180, 3

Avenue, L’Islet, Quebec, G0R 2C0 CANADA

Tel.: (418) 247-3947, 1 800-463-7043

Fax: (418) 247-7801, 1 800-662-7801

www.ouellet.com

INSTALLATION INSTRUCTIONS

“OVE Series”

RECESS WALL MOUNTING
1. Use the template provided with the heater.

Make a minimum opening of 2 in. (51 mm) deep. Recom-

mended distance from heater to ﬂ oor is 12 in. (305 mm).
2. Remove the heater front panel.
3. Remove the connection box cover.
4. Remove the appropriate knock-out from the box for the
electrical supply.
5. Secure the heater by using the provided screws. Remove
3/16 in. (4.8 mm) side knock-outs or use the holes at the
back of the heater.
6. Make connections according to local and national codes.
7. Put all covers back on the heater and test.
a) Adjust heater thermostat at maximum setting (1500W).
b) Slowly turn down thermostat setting for 750W output.
(Model T and TM).
c) Adjust thermostat at minimum setting and set the timer
(1500W) (Model TM).

SURFACE WALL MOUNTING
1. Locate the power supply leads behind the planned location
of the heater. Recommended height from heater base to
ﬂ oor is 12 in. (305 mm).
2. Follow steps 2 to 7 of the RECESS WALL MOUNTING.

CONTROL
Without control:
Maintains room temperature by a line-voltage wall thermostat
approved for inductive loads (not supplied). A pulsating elec-
tronic thermostat must not be used with this model. (1500W)
With thermostat:
Maintains room temperature 750W (low-speed). Thermostat
automatically changes heater from 750W (low-speed)
to 1500W (high-speed) when necessary.
With thermostat and timer combination:
Maintains room temperature 750W (low-speed). The unit
automatically changes to 1500W (high-speed) when neces-
sary. The 0-60 minute timer allows for quick heat-up to 1500W
(high-speed) before a bath or shower. The heater returns to the
thermostat mode automatically or manually.

ATTENTION

Basic precautions should always be taken to reduce the risk of
ﬁ re, electric shock, and injury:
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Keep combustible materials, like
furniture, pillows, bedding, papers, clothes, and curtains at
least 48 in. (1220 mm) from the front of the heater.
- We recommend to keep a distance of 39 1/2 in. (1004 mm)
minimum from a bathtub according to local and national
codes.
- Do not use outdoors.
- Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or ﬁ re,
or damage the heater.
- Do not block air intakes or exhaust in any way whatsoever.
- A heater has hot and arcing or sparking parts inside. Do not
use it in areas where gasoline, paint, or ﬂ ammable liquids
are used or stored.
- Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause ﬁ re, electric
shock, or injury.

KEEP THIS INSTRUCTION PAMPHLET

FOR THE USER INS22-200306-05

WARRANTY

OUELLET CANADA INC. warrants the electric heating element of the OVE series for ﬁ ve (5) year period; and its component parts
against defects in material and workmanship for a two (2) year period following the date of purchase, under normal use and service,
when proof of purchase of such is provided to the manufacturer. The obligation of Ouellet Canada inc., under the terms of this war-
ranty, will be to supply a new unit and this releases the manufacturer from paying the installation costs or other secondary charges
linked to replacing the unit or the component part(s).

ATTENTION (CONTINUED)

AMERICAN VERSION ONLY: This heater includes a visual
alarm to warn that parts of the heater are getting excessively
hot. If the light turns on, immediately turn the heater off and
inspect for any objects on or adjacent to the heater that may
cause high temperatures. DO NOT OPERATE THE HEATER
WITH THE ALARM LIGHT IS ON.

MAINTENANCE
- Once every quarter, remove the front panel and use a vacuum
cleaner to remove the dust accumulation inside the heater.
- Cleaning should be done while the heater is disconnected
from the main service panel.
- A qualiﬁ ed technician should perform any other servicing.

NOTICE
Heater will produce a light smoke when it is new and energized
for the ﬁ rst time. It is normal, and will end a couple of minutes
later.
When the heater is used in a dusty or smoky environment, the
air exit grill may turn yellow. To alleviate the problem, we sug-
gest that you clean the heater hot air exit more often especially
when dust and smoke cannot be avoided. Never let the heater
function in a very dusty environment.

RECESS WALL MOUNTING

SURFACE WALL MOUNTING

Wall opening
11 11/16’’ X 15 1/16’’ X 2’’
(296 mm X 383 mm X 51 mm)

Ground screw

Connection box cover

Holes for

recess mounting

Front

panel

2’’ (51 mm)

1 3/4’’ (45 mm)

2 3/8’’ (60 mm)

Wire cable

outlet

KOE Ø7/8’’

KOE Ø22 mm

10 1/2’’ (266 mm)

Screw

positions

KOE Ø3/16’’

KOE Ø4.8 mm

1/2’’

(12 mm)

This drawing indicates screw positions

and wall area cover by the heater.

Surface

of the heater

9 1/2’’

14 13/16’’

241 mm

376 mm

8 7/16’’ (214 mm)

1/2’’

(12 mm)