Ouellet ODS - Manual

180, 3 rd Avenue, L’ISLET, Quebec, G0R 2C0 CANADA
Tel.: (418) 247-3947, 1-800-463-7043 Fax: (418) 247-7801
www.ouellet.com
INSTALLATION INSTRUCTIONS
ODS Series - ODSA Model
Surface Mounting (2 to 5 kW)
KEEP THIS INSTRUCTION PAMPHLET
FOR THE USER
INS83-200404-03
IMPORTANT:
MUST BE INSTALLED SOLIDLY
This heater could weight up to 25 lb (11 kg)
STANDARD CEILING MOUNTING
1. Never install the air-forced diffuser at less than 8 ft. (250 cm)
from
the fl oor and 12 in. (30 cm) from adjacent walls.
2. Provide an exit for the power supply wires in the ceiling,
under the heater.
3. Mount the ceiling support using provided screws.
For drop ceiling mounting, the necessary kit is not provided.
4. Suspend the heater at the hangers of the ceiling support.
5. Convey the wires of power supply to the junction box of the
heater and connect the heater leads to the supply leads
according to the local and national codes.
See wiring diagram.
6. Fold back the heater toward the ceiling and fi x it using
the screw provided..
7. Install the front cover using the 3 screws provided.
DROP CEILING MOUNTING
(with option ODS-T-BAR)
1. Install the ODS-T-BAR on the ceiling using chains, steel
wires or bar.
2. Mount the ceiling support on the ODS-T-BAR option.
3. Follow instructions 4 to 7 as above for STANDARD
CEILING
MOUNTING.
OPTIONS
See installation pamphlet provided with the various options for
the installation of those options.
ATTENTION
Basic precautions should always be followed to reduce the risk
of fi re, electric shock, and injury to persons.
- Read all instructions before using this heater.
- Do not use outdoors.
- Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock, fi re,
or damage to the heater.
- Do not block air intakes or exhaust in any manner.
- Heater contains arcing and sparking parts. Do not
use it in areas where gasoline, paint, or fl ammable liquids
are used or stored.
- Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fi re,
electric shock, or injury to persons.
- Use copper wire only.
- The motor is thermally protected.
MAINTENANCE
Once a year, remove the front cover and use a vacuum cleaner
or compressed air to remove the dust accumulation inside the
heater. Cleaning should be done while the heater is disconnected
from the power supply circuit.
A qualifi ed technician should perform any other servicing.
WARRANTY
OUELLET CANADA INC. warrants the electric heating element
of the ODSR Series for a ten (10) year period; and its compo-
nent parts against defects in material and workmanship for a one
(1) year period following the date of purchase, under normal use
and service, when proof of purchase of such is provided to the
manufacturer. The obligation of Ouellet Canada Inc., under the
terms of this warranty, will be to supply a new unit and this omits
the manufacturer to bear the installation costs or other secondary
charges linked to replacing the unit or the component part(s).
IMPORTANT
Connect the control (thermostat or relay)
to the T1-T2 position on the terminal block.
Do not interrupt power supply to control this heater.
THE INSTALLATION MUST BE EXECUTED
BY A QUALIFIED TECHNICIAN
RISK OF ELECTROCUTION
ODSA (2 to 5 kW) ODS-T-BAR
2
1