FUTEK IHH500 Series - Manual (Page 9)

9
The decimal point can be moved by
selecting it first and turning it into a
number, and then selecting another
digit to change it into a decimal point.
Sensitivity (+) must be entered. If only
one direction is selected, then sensitivity
(+) will be applied to both directions of
output or negative direction output.
Sensitivity is the sensor’s output level,
such as mV/V output, and is found on the
calibration certificate.
Pressing back without saving will prompt
to exit without saving. Enter can be used
for Yes, and Back for No.
IHH500 Elite supports Encoders through
Pulse profiles.
Current profiles cannot be set up
manually and must be set up using the
Live Calibration feature in the profile
setup.
Full bridge sensor type is for mV/V
output sensors.
TIPS FOR SETTING UP A PROFILE