FUTEK IPM650 Series - Manual (Page 10)

10
TEDS is a small chip that can store a sensor’s calibration information. The IPM650 can read it upon power up, or by loading it
through the menu, and setup a profi le with the stored information.
TEDS MENU
1. Menu
2. TEDS Data
3. TEDS Device — Will show information about TEDS chip.
4. TEDS Pages — Shows programmed information stored
in chip.
5. Load Data — Will load TEDS information into IPM650.
6. Auto Detection — Sets the IPM650 to automatically
load TEDS information upon power on.
CHANNEL SELECT (CALIBRATION PROFILE SELECT)
1. Menu
2. System Setting
3. Channel Select
4. Use the left and right arrow key to choose the desired
channel.
5. Enter to load Channel or Profi le.
TEDS and Channel Select
10
TEDS calibration information can be
viewed upon loading TEDS, either
during a power on or while selecting
Load Data under the TEDS menu. The TEDS chip should be placed within
5ft. of the IPM650 sensor connection to
maintain proper power. An auto-calibration may be performed
when loading TEDS information, or a
new channel or profi le.
TIPS FOR USING TEDS AND CHANNEL SELECT
332179_Futek_IPM650_r2.indd 10 332179_Futek_IPM650_r2.indd 10 9/11/13 9:32 AM 9/11/13 9:32 AM