Dwyer ULT - Manual (Page 7)

BLIND ZONE
8 [203.2]
HEIGHT
(MAX R)
(MIN R)
FILL H
TaRGeT CaL MenU
Target Calibration sets the tank empty and tank full distances for
the transmitter output based on the actual level in the tank. This
is good to use if the tank dimensions are unknown or if it is
desired to fill and empty the tank for precise measurement
points. Press inDeX to advance to the next menu time. Press
enTeR to retain the value. See Figure 8 below.
fULL
Fill the tank to the full liquid level desired. Press enTeR and this
level will be saved.
eMpTY
Drain the tank to the empty level desired. Press enTeR and this
level will be saved.
HeLp
Displays a guide to the menu items in this menu. Press enTeR
to display.
eXiT
Exits TaRG CaL menu and goes back to the top menu. Press
enTeR to go back to the top menu or press inDeX to loop back
through the TaRG CaL menu options.
figure 8: Target Calibration
VaLUeS MenU
SeTUp
Displays the current programmed setup for the unit. This is
scrolling data that will return to the VaLUeS menu after display-
ing all the parameters. Values shown are: MeaSUR, then the
setting; UniTS, then the setting; SHOW, then the setting;
HeiGHT, then the setting; fiLL H, then the setting; Safe, then
the setting; ReV Ma, then the setting.
DiaGnOSTiCS
Displays diagnostic items that may be relevant to the transmitter
and its performance in the application. This is scrolling data that
will return to the VaLUeS menu after displaying all the parame-
ters. Values shown are RanGe, then the setting; TeMp, then
the setting; eCHO, then the setting; pOWeR, then the setting;
VeR, then the setting.
ReSeT
Resets the programming to factory default settings.
YeS Resets the programming to factory default settings.
nO Exits without making changes.
eXiT
Exits VaLUeS menu and goes back to the top menu. Press
enTeR to go back to the top menu or press inDeX to loop back
through the VaLUeS menu options.
HeLp MenU
Contains contact information for Dwyer Instruments, Inc.