Dwyer 3200G - Manual (Page 19)

6.4.2.2 Fail Mode Jumper Switch and EEPROM-Write
Fail-mode jumper switch and EEPROM-Write is located behind
the front cover.
Page 18
Figure 6-3 Structure of Electronics Module
Appendix I
3200 SMART PRESSURE TRANSMITTER - LCD DISPLAY CODE
Message
ADJ-U
ADJ-L
ZERO
SPAN
BT-ERR
P-LOCK
ZT-ERR
-TR-
ZR-ERR
SP-ERR
-ZR-
-SP-
-ZA-
-DONE-
RNGOVR
LCD_OV
SCD-ER
F-RST
F-LOCK
F-FAIL
-FR-
A-RST
A-STOR
A-FAIL
-AC-
S-FL
S-OP
AEP-RF
TS-FL
AEP-WF
EOSC
FAVE Description
Zero adjustment value – used to configure transmitter when it is out of range (on higher side)
Zero adjustment value – used to configure transmitter when it is out of range (on low side)
Initial message when using Zero button
Initial message when using Span button
Button Sequence error
Button input error - Protect Locked
Zero Trim value is over limit (10%)
Zero Trim done
Setting Limit error when executing Zero button function
Setting Limit error when executing Span button function
Zero button function done
Span button function done
Zero Adjustment done
Configuration completed using buttons
Limit error when executing other setting function
Over Values for LCD
Sensor Code Error
Flash Setting Data Reset
Flash Setting Data Reset, Protect Locked
Flash Setting Data Reset Failure
Flash Reset done
Analog EEPROM Initializing Start
Analog EEPROM Stored
Failure in writing configuration values on to the EEPROM of transmitter CPU
Analog EEPROM Configuration done
Sensor Fail
Sensor Overpressure
Check error with EEPROM on CPU board
Temperature Sensor Error
Analog EEPROM write fail
Crystal Element Defect Alarm
Flash Access Violation