9 reset to default 32, Reset to default – West Control Solutions TB 45 Temperature Monitor User Manual
Page 32

g
When an alarm is still pending, i.e. unless the error cause was removed (E display blinks), latched alarms
cannot be acknowledged and reset.
6.9
Reset to default
In case of faulty configuration, the device can be
reset to the default manufacturers condition.
1
For this, the operator must keep the keys
increment and decrement pressed during
power-on.
2
Then, press key increment to select
YES
.
3
Press enter to call up the password menu and
to enter the valid password. If the password
is faulty, reset is not possible.
4
Confirm factory resetting with Enter and the
copy procedure is started
(display
COPY
).
5
Afterwards the device restarts.
In all other cases, no reset will occur (timeout
abortion).
g
If one of the operating levels was blocked in
BlueControl
Ò
, reset to factory setting is not
possible.
g
The copy procedure (
COPY
) can take
some seconds.
g
Now, the transmitter is in normal operation.
Functions
32
Reset to default
TB 45
FAC
torY
FAC
no
+ Power on
FAC
yEs
ô
FAC
PASS
8.8.8.8
#:#:#:#:#
дддд
1
2
3
4
5
FAC
COPY
ф