Thermo Fisher Scientific Alpha TDS 200 - Manual (Page 26)

22
8.8 Viewing TDS / Temperature Electrode Data – P6.0
Program 6 has two “view only” options that let you check the electrode parameters for
diagnostic purposes.
P6.1: view revised cell correcting factor value of electrode
P6.2: view temperature probe offset (ATC on only)
These parameters will change each time you recalibrate the controller.
P6.0
elec
P6.1 P6.2
t.ofs
0.0 1 000
.
FCTR
Press ▲and ▼keys together (ESCAPE) at anytime, to leave the Setup mode and return
to Measurement mode.
P6.1: Viewing TDS electrode data
1.
Key in the password “022” as per procedure in Section 5.
2. Press ▲key until screen displays P6.0 and ELEC. Press ENTER.
3. Screen will scroll P6.1, ‘FCTR’ then cell correction factor. Each time a calibration is
performed, the value of the cell correction factor will be updated.
4. Press ▲and ▼keys together (ESCAPE) to return to P6.0 or press ENTER to view
Temperature electrode data.
P6.2: Viewing Temperature electrode data
5.
Follow procedure from above (P6.1) until step 3 and press ENTER.
6. Screen will scroll P6.2, ‘T.OFS’ (Temperature Offset), then amount of offset (in o C).
7. Press ENTER or press ▲and ▼keys together (ESCAPE) twice, to return to
measurement mode.