Thermo Fisher Scientific Eutech pH 700/Ion 700 - Manual (Page 11)

8
4. STORING AND RECALLING DATA
The 700 series meters can retain up to 100 points into memory for
later retrieval.
1) In the measurement mode, press
to insert the measured value into
memory. The stored memory location value (StO) is briefly displayed.
2) To recall data from memory, press
. The location of the most recent
stored data is displayed first. Press or to select the location of
the desired data, then press to accept.
3) Press
to return to the stored data location. Press to return to
measurement mode. To erase stored data, see Section 5.8.
5. SETUP FUNCTIONS
Use the set up mode to customize your instrument operation. During
measurement, press and hold
for 5 seconds to enter SETUP mode.
Press or to change programs or change options.
Press to select the program or confirm selection.
Press to go back a level or to return to measurement mode.
5.1 P1.0 CAL (Calibration)
Press to view each stored calibration point.
5.2 P2.0 ELE (Electrode Information)
Press to view mV offset (OFS) in mV and pH modes only.
Press to view % slope (SLP) in pH and Ion modes only.