Thermo Fisher Scientific CyberScan CON 400/410 (For units manufactured before March 2010, discontinued) - Manual (Page 45)

Instruction Manual CON 400/410
- 39 -
7.9 P8.0: Resetting to factory default settings
Program 8.0 lets you reset all parameters to factory default settings. This clears all calibration
data, memory, and any other setup functions you might have changed. It does not clear clock
settings.
From measurement mode
1. Press
SETUP key to enter Set Up mode.
2. Press the MI/S or MR/T keys to scroll through
subgroups until you view parameter P8.0.
3. Press the ENTER key to enter parameter P8.0.
4. Press the MI/S or MR/T keys to toggle between NO
and YES. NO retains current settings; YES resets to
factory default settings.
5. Press the ENTER key to confirm selection and to
return to the measurement mode. Otherwise press
CAL/MEAS key to return to measurement mode
without resetting to factory default.
See Figure 35.
NOTES:
See Addendum 4 on page 48 for a table of factory default
settings.
Figure 35 - P6.0: Reset to
factory default values