SHIMPO TNP-Series - Manual (Page 16)

15
XIII. How to recall stored Memory
Select Open or Close Mode, press the Recall key and the display will indicate the
number of data stored in memory.
Press Recall key second time to access the following information.
• AVERAGE Value
• MAX Value
• MIN Value
• Stored data (Data order of recall is based from the last data stored in
memory)
Displays Max Values after pressing Recall
To access the stored measured value use the Recall key to scroll thru the values.
(This will be after the MIN value is displayed). The display will flash two sets of
numbers, the first number indicates the memory ID and the second number is the
value stored on that memory ID.
NOTE: The order of values is from the last data stored to the first data stored. To
review previous values shown, scroll through the values using the Recall key.