SHIMPO ST-5000 - Manual (Page 3)

Tach Main Menu
CAUTION Sub-Menu: Caution Statement for Class II Lasers.
MEASURE Sub-Menu: Measure the rate of speed of the process
in RPM or Hz. MAX and MIN data are recorded. Reset the MAX
and MIN recordings by pushing in and releasing the scroll dial
button.
CAUTION: In this menu Class II Laser is active.
GRAPH Sub-Menu: View the process speed in a graph format
over a 60 second rolling period. Reset the graph by pushing in
on the scroll dial button. One dot equals one second on the X-axis
or horizontal scale. The graph’s Y-axis or vertical scale can be
adjusted in the Y Scale sub-menu in the SET Main Menu.
CAUTION: In this menu Class II Laser is active.
NO DATA
Laser Radiation
Do not stare into beam
Class 2 laser product
CAUTION
STROBE TACH SET *1
DATA IN
MAX: 7988
MIN: 50.00 MEASURE
STROBE TACH SET *1
0 RPM 7008
DATA IN
1786
1746
1706 6.00 GRAPH
STROBE TACH SET *1
02
RPM
/
Dot
SET Main Menu:
FL DUR Sub-Menu: The flash duration sub-menu allows you to
adjust the flash’s duration or on time. The factor is 1-5. The higher
the factor level selected the longer the flash duration and brighter
the flash. However the viewed image may be blurry. The lower
the factor level selected the shorter and dimmer the flash, how-
ever the viewed image may be clearer. Note: The flash duration
automatically adjusts within each of the 5 level settings as the rate
of speed changes. Except when the flash rate is below 3000 the
duration will not automatically adjust and will remain fixed at a
certain time within each setting. Below a rate of 300, the 5 level
settings are all equally fixed at the same time and no change in
duration can occur.
Hz RPM Sub-Menu: Change the units from Hz to RPM by adjust-
ing the scroll dial.
Y Scale Sub-Menu: Adjust the Y axis of the graph. The rate can
be adjusted from 1 RPM to 100 RPM/Dot by moving the scroll dial
up or down.
FLASH DURATION: 01
FL DUR
STROBE TACH SET *1
Unit :RPM
Hz RPM
STROBE TACH SET *1
RPM/Dot: 100
Y SCALE
STROBE TACH SET *1
3