Revo REXN700-2 - Manual (Page 16)

N>D: Adjust level that changing point of Night -> Day.
- OPD: Optical detector value. Represent present physical brightness.
- Use Alt Camset(N), Alt Camset:
Select camera configuration set to apply in night mode.
NOTE:
* Not support in single camset mode.
6) EXT-I/O
- D/N OUT (Day&Night Output) : Select output method, No Func/D/N Out/AUX0
AUX0: User Defined output 0.
Set AUX0: Output voltage through to D/N OUT port (On:5V/Off:0V)
- ALARM OUT: Select output method, No Func/Alarm Out/AUX1
AUX1
: User Defined output 1.
Set AUX1: Output voltage through to D/N OUT port (On:5V/Off:0V)
- D/N IN : Select input method. No Func/Alt Camset.
Alt. Camset: When inputted signal, change camera configuration.
Select camset number
7) Counter: Configurations for output of counting machine.
- ,
:
Represent counting value / adjust offset value.
- Alarm On Zero: When counter value reached zero, will be alarmed.
Preset Cnt1, Cnt2 : When counter reached zero, counter value will be reset this
value.
Reset
: Initialize counter. (Default Zero, or Alarm on zero enabled: Offset Value)
TextOut to Comm
: Event string sends through RS-485 lines.
NOTE:
* Event Out must be activated.
16