Revo REXN700-2 - Manual (Page 15)

Unregist
: Deleting registered pixel.
NOTE:
* No more exist register pixel, Print “Memory empty” and stops action.
Marker
: Select for if you continue unregister action.
UnDo
: Cancel the unregistered point.
Done
: Return to previous menu.
Default
: Recover to factory adjustment state.
- Focus Aid
For prevent the spread of light, AE mode changed to Shutter Fix Mode.
Min SHT (sec)
: Adjust minimum shutter speed.
Zoom
: Zoom to focus window.
Adj: Adjust.
Start
: Start measurement of maximum focus value.
Stop: Stop the measurement. And initialize maximum focus value.
NOTE:
* FAD Max: Hold maximum focus value.
* FAD Val: Print present focus value.
* Usage:
Step1: Point target to focus window.
Good target: higher contrast, more complex patterns.
Step2: Minimize the spread of light with adjust shutter speed.
Step3 : Turn the lens focus ring to end, start “Adj”
Step4: Turn the lens focus ring slow by opposite side, record max focus value.
Step5: If current fad value is lower than Max fad value, stop turning focus ring.
Step6: Adjust focus ring to be closer to the max fad value.
3) Lens
: Select lens (DC lens/Video lens/Manual Lens)
- Iris Speed: Only for DC/Video Lens, Adjust Iris speed.
NOTE:
* If iris speed is too high, it can occur AE hunting.
* If iris speed is too low, IRIS adjusting operate too slowly.
4) LLC (Line Lock Control)
Active only used AC Power. - Int(Internal)/Ext(External)
If mode is set to Ext, Sync Phase can be adjusted.
5) Day/Night
- Detection: Configuration D/N change method. (Internal/Fix-Day/Fix-Night/EXT-IN)
Internal: Operating DN changing with internal detection algorithm.
Fix-Day: Day mode fixed.
Fix-Night: Night mode fixed.
External: Work with EXT-IN mode. If port input voltage is high,
DN mode is Night. And If port w voltage is low, DN mode is Day.
- Burst: Select burst signal on/off at night mode.
- Delay (sec): Select Delay time in D/N mode changing.
- D/N Threshold
: Configuration for threshold level in D/N mode changing.
(Low/Mid/High/User)
NOTE:
* User Mode : Difference of D>N Level and N>D Level must be more than 2,
and D>N must be less than N>D.
D>N: Adjust level that changing point of Day -> Night.
15