NOSHOK 800 Series Electronic Indicating Pressure Transmitter/Switch - Manual (Page 8)

7
Enter the user menu by pressing
the buttons S1 + S2 for at least 3s.
Preset-authorization for the user
The user has the permission
YES: To delete the max-min-memory
NO: Do not delete the max-min-memory
Only required for activated password.
[PA.En]
Choice of measuring unit.
Applies to all further settings.
Display of the measuring unit.
The measuring unit is shown in the display.
YES: 1s after every 10s
NO: Not shown
Select the first switching point.
Select delay time of the first switching output.
Range: 0.00 ... 99.99s
Resolution: 0.01s
Select contact function of the first switching point.
ncLS: Normally closed contact
noPn: Normally open contact
Change password.
Only possible with activated password.
[PA.En]
Activate password.
YES:
Password is required
NO: Password is not required
M a i n P r o g r a m m i n g - S e t U p M e n u
= These steps are available
on switches configured with
the Enchanced Software
Option Only.
Function of the buttons:
S1
to run through the menu points,
to change the value
S2
to select menu point,
to return to the menu point
7
Enter the user menu by pressing
the buttons S1 + S2 for at least 3s.
Preset-authorization for the user
The user has the permission
YES: To delete the max-min-memory
NO: Do not delete the max-min-memory
Only required for activated password.
[PA.En]
Choice of measuring unit.
Applies to all further settings.
Display of the measuring unit.
The measuring unit is shown in the display.
YES: 1s after every 10s
NO: Not shown
Select the first switching point.
Select delay time of the first switching output.
Range: 0.00 ... 99.99s
Resolution: 0.01s
Select contact function of the first switching point.
ncLS: Normally closed contact
noPn: Normally open contact
Change password.
Only possible with activated password.
[PA.En]
Activate password.
YES:
Password is required
NO: Password is not required
M a i n P r o g r a m m i n g - S e t U p M e n u
= These steps are available
on switches configured with
the Enchanced Software
Option Only.
Function of the buttons:
S1
to run through the menu points,
to change the value
S2
to select menu point,
to return to the menu point
7