Martel Electronics MC1210 - Manual (Page 47)

47
ST_START
Starts a switch test.
TC_TYPE
Sets the type of the thermocouple. All available types are shown in the TC Types table in
Section 8. (Specifications). For example:
TC_TYPE B sets thermocouple type to B
TC_TYPE?
Returns the type of thermocouple the calibrator is set to.
TEMP_UNIT
Sets the temperature unit for sourcing and measuring RTD and TC. Add CEL after the
command for Celsius, and FAR for Fahrenheit. For example:
TEMP_UNIT CEL sets the temperature to be measured or sourced to Celsius.
TEMP_UNIT?
Returns the temperature unit that is currently used for measuring and sourcing RTD and TC.
TRIG
Starts and stops the pulse train when the calibrator is in pulse mode. The parameters of the
pulse train are set by commands PULSE_CNT, and FREQ_LEVEL. Entering TRIG initializes
the train. Entering the command while the pulse train is running stops it.
TRIG?
Returns TRIGGERED if the pulse train is running, and returns UNTRIGGERED when the pulse
train is not running. Returns NONE when the calibrator is not in pulse mode.
TSENS_TYPE
Sets the temperature sensor type to thermocouple, or to RTD for temperature measurement.
After the command add TC for thermocouple, or RTD for RTDs. For example:
TSENS_TYPE TC sets the sensor type to thermocouple
TSENS_TYPE?
Returns the type of sensor that is currently set to measure temperature, either TC or RTD.
UPPER_MEAS
Sets the measuring mode for the upper display. After the command enter DCI for mA,
DCI_LOOP for mA with loop power, DCV for volts, and PRESSURE for pressure. For example:
UPPER_MEAS DCV sets the upper display to measure volts