Martel Electronics MC1210 User Manual

Page 46

RTD_TYPE

Sets the RTD type. The following is a list of RTD types they way they should be entered after
the command:

PT385_10;

PT385_50;

PT385_100;

PT385_200;

PT385_500;

PT385_1000;

PT392_100;

PTJIS_100;

Ni120;

Cu10; Cu50;

Cu100;

YSI_400;

OHMS;

CUSTOM;

For example:

RTD_TYPE PT385_10 sets RTD type to Pt385-10

RTD_TYPE?

Returns the RTD type.

RTD_WIRE

Sets the number of wires used for connection in measuring RTDs. The calibrator measures
RTDs using 2-, 3-, and 4-wire connections. After the command, enter 2W for 2- wire, 3W for 3-
wire, and 4W for 4-wire. For example:

RTD_WIRE 4W sets the connection to 4-wire

RTD_WIRE?

Returns the number of wires used in the RTD connection.

SIM

Sets the output for current simulation. This command also switches the calibrator into mA
simulation mode. A number and a unit must be entered after the command. For example:

SIM 5 MA sets the current simulation at 5 mA

SIM?

Returns the output of the current simulation. With the example above, the output would be:

5.000000E-03, A

ST_CLOSE?

Returns the value that the switch closed at in the current units.

ST_DEAD?

Returns deadband of the switch in the current units.

ST_OPEN?

Returns the value that the switch opened at in the current units.