Saving the configuration, Pr el im in a ry – ADC 500L User Manual
Page 50
Saving the Configuration
PRELIMINARY
42
Megabit Modem 500L Installation Manual
PR
EL
IM
IN
A
RY
2
Click
Add
to accept the
Static NAT Entry
.
3
Repeat
and
to add up to 32 static NAT entries.
4
To delete a
Static NAT Entry
, highlight the entry in field
then click
Delete
.
5
Click
Done
to return to the
PPP over ATM LAN Configuration
page.
S
AVING
THE
C
ONFIGURATION
Although you have submitted new settings, the parameters are not permanent until you write
them to NVRAM. See
“Saving the Configuration” on page 21
to save the WAN and LAN
configurations to NVRAM.
Enter the
Remote IP Address
for a user at a remote site that you are mapping to a user
on the LAN (LAN user was entered in field
of the
Static NAT Entry
shown above).
Port
is the logical port for the protocol (UDP or TCP) you select for this NAT entry
.
Your system administrator will provide the protocol port number.
If you do not have the information for the remote user and port, enter 0.0.0.0 for the
Remote IP Address
and/or 0 for the
Port Address
.
Select a
Protocol
(UDP or TCP) for the transport used between the LAN and the
remote user for this static NAT entry. (See
for more information
about the transport protocols.)
This field lists the
IP Address
,
Port,
and
Protocol
for the
Private
,
Proxy
and
Remote
fields defined. You can have up to 32 static entries.