Pr el im in a ry – ADC 500L User Manual
Page 48
Configuring PPP over ATM Sessions
PRELIMINARY
40
Megabit Modem 500L Installation Manual
PR
EL
IM
IN
A
RY
4
Click
Submit
after completing the LAN configuration page.
5
After changing a LAN IP address and subnet mask (or changing the IP address and subnet
mask), effect the configuration by completing the procedures for
The modem automatically assigns the
Start IP Address
for the first device on the LAN
as one address higher than the Ethernet port on the modem, when DHCP is enabled.
You cannot edit this field.
Enter the IP address for a device that will be the
Primary DNS
. The primary Domain
Name System (DNS) device translates human-readable machine names into IP
addresses. (See
for more information on DNS resolution.)
Enter the IP address for a device that will be the
Secondary DNS
. The DNS device
translates human-readable machine names into IP addresses. (See
for more
information on DNS resolution.)
The modem automatically enters the
Gateway
IP address which is the same
IP address as the LAN (Ethernet) 10/100BASE-T port of the modem. You cannot
edit this field.
Click
Static NAT Table
to open a dialog in which you can map inbound Internet traffic
to specific sessions. Go to the section on
“Defining Static NAT Entries” on page 41
to configure these parameters. Configuring Static NAT entries is optional.