KYORITSU 3127 - Manual (Page 51)

－ 48 －
10．Battery Charging and Replacement
10-1 How to charge battery
# DANGER
Use only the Power adapter supplied with this instrument.
Connect the Power adapter to a mains socket outlet. The mains supply voltage
must not exceed AC240V.
Handling and storage instructions specifi ed by the battery manufacturer should
be observed.
# WARNING
Never attempt to make any measurement if any abnormal conditions, such
as a break on the Power adapter or exposed metal parts are present on the
instrument. When unplugging the Power adapter from the mains socket outlet,
do so by removing the plug fi rst and not by pulling the cord.
(1) Set the Range Switch to the OFF position.
(2) Confi rm a battery is installed in the instrument.
(3) Slide the shutter of the terminal to the measurement terminal side and connect
the Power Adapter.
(4) LED Status Indicator fl ashes in red and the Battery Mark also fl ashes on the
LCD.
(5) The indicator lights up in green and the Battery Mark on the LCD stops fl ashing
and lights up. (Battery charge completes in about 8 hours.)
* KEW3127 cannot perform measurement while charging battery.
* Battery life and how many times can be
charged are depended on conditions of use
and environment.
* Storing rechargeable lead-acid batteries in a
low-charged state could lead to reduced life
and/or damage. When storing the battery for
a long period, check and charge the battery
at regular intervals.
-50- 50