KROHNE OPTIMASS 6000 EN - Manual (Page 5)

SAFETY INSTRUCTIONS
1
5
OPTIMASS 6000
www.krohne.com 07/2014 - 4001894003 - MA OPTIMASS 6000 R03 en
Safety instructions
1.1 Intended use
This mass flowmeter is designed for the direct measurement of mass flow rate, product density
and product temperature. Indirectly, it also enables the measurement of parameters like total
mass, concentration of dissolved substances and the volume flow. For use in hazardous areas,
special codes and regulations are also applicable and these are specified in a separate
documentation.
1.2 CE certification
This device conforms with the following EC directives:
• EMC Directive 2004/108/EC
• ATEX Directive 94/9/EC
• Low Voltage Directive 2006/95/EC
• Pressure Equipment Directive 97/23/EC
The manufacturer declares conformity and the device carries the CE mark.
1.3 Associated documents
This handbook should be read in conjunction with relevant documents in relation to:
• hazardous areas
• communications
• concentration
• corrosion
1.4 Insulation case
On meters fitted with an insulation case, the case will be filled with one of the following
materials:
Cryogenic meters Cryogenic meters Cryogenic meters Cryogenic meters (-200°C...+40°C / -364°F...+104°F)
Block grade EPS 1112A (Polystyrene) containing flame retardant additive (FRA)
Standard meters Standard meters Standard meters Standard meters (-70°C...+230°C / -94°F...+446°F)
Glass mineral wool
CE marking
MA_OPTIMASS_6000_en_140717_4001894003_R03.book Page 5 Thursday, July 17, 2014 3:27 PM