KROHNE OPTITEMP Compact sensors - Manual (Page 5)

SAFETY INSTRUCTIONS
1
5
OPTITEMP TRA-CXX
www.krohne.com 02/2014 - 4003290501 - MA OPTITEMP TRA-Cxx R01 en
Safety instructions
1.1 Intended use
The compact sensors are used to measure the temperature of gases, liquids, vapour and solids
in industrial applications with limited installation space. The devices are particularly suited to
the measurement of
• liquids with low viscosity
• water and chemicals with low corrosiveness
1.2 Approvals and certifications
1.2.1 CE
Article 1, section 2.1.4 of the Pressure Equipment Directive 97/23/EC does not apply to compact
thermometers. For this reason, neither a conformity assessment nor a CE marking is possible.
The EC directives applicable to temperature transmitters are contained in transmitter part of
this documentation.
1.3 Safety instructions from the manufacturer
1.3.1 Copyright and data protection
The contents of this document have been created with great care. Nevertheless, we provide no
guarantee that the contents are correct, complete or up-to-date.
The contents and works in this document are subject to copyright. Contributions from third
parties are identified as such. Reproduction, processing, dissemination and any type of use
beyond what is permitted under copyright requires written authorisation from the respective
author and/or the manufacturer.
The manufacturer tries always to observe the copyrights of others, and to draw on works created
in-house or works in the public domain.
The collection of personal data (such as names, street addresses or e-mail addresses) in the
manufacturer's documents is always on a voluntary basis whenever possible. Whenever
feasible, it is always possible to make use of the offerings and services without providing any
personal data.
We draw your attention to the fact that data transmission over the Internet (e.g. when
communicating by e-mail) may involve gaps in security. It is not possible to protect such data
CAUTION!
Responsibility for the use of the measurement devices with regard to suitability, intended use
and corrosion resistance of the used materials against the measured fluid lies solely with the
operator.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
.book Page 5 Friday, February 7, 2014 9:17 AM