KROHNE PTITEMP TT 20 C EN - Manual (Page 16)

4
ELECTRICAL CONNECTIONS
16
OPTITEMP TT 20
www.krohne.com 10/2011 - 4000753102 - MA OPTITEMP TT 20 R02 en
4.3 Connection diagram
CAUTION!
Always establish the electrical connections according to the following diagrams. Otherwise it
can come to destruction or damage of the transmitter. Note that the maximum output load
always depends on the power supply. If the maximum output load is exceeded, then the
measured value will become incorrect. For further information refer to the output load diagram
in the chapter "Technical data" on page 25.
Figure 4-2: Connection diagram
1 Voltage supply 8.5...32 VDC (terminals 6,7)
2 R
Load
3 Input
4 Output signal (4...20mA)
5 Pt100 3-wire connection
.book Page 16 Friday, October 14, 2011 11:22 AM