KROHNE PTITEMP TT 20 C EN - Manual (Page 13)

INSTALLATION
3
13
OPTITEMP TT 20
www.krohne.com 10/2011 - 4000753102 - MA OPTITEMP TT 20 R02 en
3.3 Rail mounting kit for in-head transmitters
The screws in the kit is not to be used with this transmitter.
1 Place the transmitter on the rail mounting kit as shown above.
2 Push the transmitter down until it reaches the plate and is attached.
INFORMATION!
The rail mounting kit allows to install the in-head transmitter on a rail according to DIN 50022.
The kit does not belong to the standard scope of delivery. You have to order it separately. For
more information refer to Accessory parts on page 19.
Rail mounting kit for in-head transmitters
Figure 3-2: Rail mounting kit for in-head transmitters
1 Rail (not included in the kit)
2 Screws (not needed)
3 Clamp
4 Transmitter
Installation procedure: Step 1
.book Page 13 Friday, October 14, 2011 11:22 AM