KROHNE PTITEMP TT 20 C EN - Manual (Page 11)

INSTALLATION
3
11
OPTITEMP TT 20
www.krohne.com 10/2011 - 4000753102 - MA OPTITEMP TT 20 R02 en
Installation
3.1 Notes on installation
3.2 In-head transmitter
The transmitter is intended for installation in DIN B connection heads or larger. The large
Ø7 mm / 0.28 inch center hole facilitates the electrical connection of the sensor and the
installation. For detailed information refer to
Dimensions on page 25.
INFORMATION!
Inspect the cartons carefully for damages or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Do a check of the packing list to make sure that you have all the elements given in the order.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Figure 3-1: Connection head installation kit
1 M4 screw
2 Spring
3 Lock washer
4 Wires from the measuring inserts
5 MI Cable
INFORMATION!
The connection head installation kit does not belong to the standard scope of delivery of the
transmitter, you have to order it separately. For more information refer to Accessory parts on
page 19.
.book Page 11 Friday, October 14, 2011 11:22 AM