KROHNE IFC 300 Converter HART 0102 - Manual (Page 3)

Supplementary Installation and Operating Instructions IFC 300 HART
HC275, FC375, AMS, PDM, FDT DTM
1 General Information
The IFC 300 is a “four-wire” transmitter with 4...20mA current output and HART
® capability. Dependent on jumper
setting and wiring the current output can operate as active or passive output.
General characteristics of the IFC 300 HART
® interface:
• Multidrop Mode is supported
• Burst Mode is not supported
Electrical connection: Refer to section “Electrical connection: outputs and inputs” of the following manual:
• “Handbook IFC 300 signal converter” (KROHNE)
There are two ways of using the HART
® communication:
a) As a point-to-point connection between the IFC 300 and the HART
® master equipment. The instrument's current
output may be active or passive.
Point-to-Point Analog/Digital Mode
4 20
mA
4...20 mA
Power
Supply
≥ 250 Ω
HART
Modem
HART
Analog
Primary Master
Secondary Master
IFC 300
Addr. 0
For slaves with
passive current
output (2 wire)
Terminal A (C)
Terminal A- (C-)
KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5 ‚ D-47058 Duisburg 3/20
Tel.: 0203-301 0 ‚ Fax: 0203-301 389 · e-mail: [email protected]