KEPCO KIT 219-0533, BOP 1000W Firmware Upgrade User Manual
Kepco, Bop 1000w firmware retrofit kit
Table of contents
Document Outline
- 1. Description
- 2. Applicability
- 3. Installation Instructions
- TABLE 1. Material Required
- FIGURE 1. Digital board A1 Prom Locations
- FIGURE 2. Distribution board A6A1 Component Location
- 4. Initialization
- 5. Instruction Manual Changes
- B.33.1 [SOURce:]LIST:REPeat Command
- FIGURE B-2A. Using List:WAIT Commands to Control Generation of a Waveform Measured by Multiple External Devices using a Single External Pulse
- FIGURE B-2B. Using List:WAIT Commands to Allow an External Device Time to Function While Imposing a Maximum Wait Time
- B.35 [SOURce:]LIST:TRIGger Command
- FIGURE B-2C. Using List:WAIT Commands to Control Generation of a Waveform Measured by Multiple External Devices using the Low-Going leading Edge of an External Pulse